UPSMAN Status Bytes - Standard Device Status Bits – Generex

UPS Status	Hex-Value	Dec-Value	Description
UPS_SB_BYPASS_MODE	0x0001	1	The Bypass is presently engaged on the UPS
UPS_SB_SHUTDOWN	0x0002	2	The entire UPS has shutdown as commanded
UPS_SB_OUTPUT_ACT	0x0004	4	Normal State, the output is on
UPS_SB_BACKUP_MODE	0x0008	8	The UPS is drawing power from the batteries
UPS_SB_BATTERY_LOW	0x0010	16	The remaining battery run-time is low
UPS_SB_OVER_TEMP	0x0020	32	A temperature is out of tolerance
UPS_SB_TEST_ACT	0x0040	64	A test is in progress
UPS_SB_INPUT_HIGH	0x0080	128	An input condition is out of tolerance r
UPS_SB_OUTPUT_HIGH	0x0100	256	The output load exceeds the UPS output capacity
UPS_SB_INVERTER_FAILURE	0x0200	512	Inverter error
UPS_SB_BATTERY_BAD	0x0400	1024	One or more batteries have been determined to require replacement
UPS_SB_ECO_MODE	0x0800	2048	eco - bypass
UPS_SB_INVERTER_WARN	0x1000	4096	eco - bypass
UPS_SB_UPS_FAILED	0x2000	8192	A general fault in the UPS has been detected
UPS_SB_COMM_LOST	0x4000	16384	A problem has been encountered in the communication to the UPS
UPS_SB_DVG_ALARM	0x8000	32768	SiteManager/SiteMonitor

Example (decimal):

STATUS= „5” means UPS_SB_OUTPUT_ACT (4) + UPS_SB_BYPASS_MODE (1) are active ! = UPS on Bypass!

STATUS= „12” means UPS_SB_OUTPUT_ACT (4) + UPS_SB_BACKUP_MODE (8) are active ! = UPS Powerfail!

STATUS= „28” means UPS_SB_OUTPUT_ACT (4) + UPS_SB_BACKUP_MODE (8) + UPS_SB_BATTERY_LOW (16) are active ! = UPS Powerfail and Battery low!

STATUS= „4” means UPS_SB_OUTPUT_ACT (4) + no other alarms = UPS OK

Verwandte Beiträge